Finally, a rear disc brake conversion that doesn't break the bank. Installation is simple, requires no welding, and it's not necessary to remove the axles. Serviceable parts are also available individually.
NOTE: This kit fits the C-clip 8.8 axles found in most F150/Bronco models. It DOES NOT fit Ford 9" bolt-in style axles (i.e., axles with a bearing retainer at the flange). If you have an axle with that style in your 80-96 F150/Bronco, check the kit HERE
Please verify your flange dimensions with the image below. This can be done without removing anything simply by measuring the flange at the back side of the drum. Even if your model is listed below, if it does not have the correct flange measurements then the kit will not fit.
NOTE: Will fit inside many *but not all* 15 inch wheels. Typically if the caliper contacts inside of the wheel, clearance can be gained by light sanding of caliper contact points.
CALIPER SELECTION: If you wish to retain your parking brake function, choose the parking brake caliper option. Please note that the Wilwood calipers are NOT parking brake capable.
Replacement Parts:
- For non-parking brake calipers/pads use same fitment as 1982 Monte Carlo Front
- For parking brake calipers/pads use same fitment as 1982 Cadillac Eldorado Rear
- For any of these and all other kit parts, use our Replacement Parts section
